Services

Our computer controlled cutting system comes with over 2,000 pre-programed shapes. However, any design can be achieved if clients provide the relevant files. For speed and precision, pneumatic tilting arms load and unload the glass while an air cushion blower system moves the glass sheet on the felt surface. The service can be applied to glass of a thickness of 3, 4, 5, 6, 8, 10, 12, 19 and 25 mm.

Beveling adds a sense of depth to the glass and is often used for ornate applications. Beveled edges have a shiny or glossy finish. The chamfered surface area ranges from 8 to 38 mm. The service can be applied to glass of a thickness of 5, 6, 8, 10, 12, 19 and 25 mm.

Sandblasted glass is produced by spraying sand at high velocities over the surface of the glass. This gives the glass a translucent surface, which is usually rougher than that obtained by etching. The depth and degree of the translucency of the finish vary with the force and type of sand used. Patterns and designs can be created using a mask which resists the abrasive force of the grit from the sandblaster. The process can be applied to glass of thickness of 3, 4, 5, 6, 8, 10, 12, 19 and 25 mm. The maximum size is 2,134 x 3,050 mm.

Our precision glass drilling machine is used for shower doors, office or residential glass, mirrors and other applications. Hole diameter ranges from 6 to 150 mm. It can be applied to glass of a thickness of (3+3), (4+4), 5, 6, 8, 10, 12, 19 and 25 mm.

This service results in an edge that is flat with small chamfers on the corners. Flat grind edgework has a matte, frosty or satin finish. Flat polish edgework provides a shiny or glossy
finish. The chamfered surface area ranges from 3 to 5 mm. It can be applied to glass of a thickness of 5, 6, 8, 10, 12, 19 and 25 mm. FGI provides single and double edging services.